These feet were made to raise the Ikea lack tables used for the Prusa enclosure.
If you are using the Prusa enclosure on the top of your desk, this is for you!
This will allow you to get more room underneath the bottom table, allowing you more room to your monitor screen.
Also you can use the space underneath the table to do other stuff or storage taller things
How to use it:
Just print 4 pieces, and put it on the feet of the bottom table. Then if required screw them to your desk.
If you don’t own a 3D Printer, use our 3D printing service and we will print and send this for you.
General height: 150mm
Width of sides: 60mm
Width at the base: 85mm
Internal Width (where the leg will sit): 51.5mm x 51.5mm
Internal Height (where the leg will sit): 25mm
Ikea lack table will rise by this amount: 125mm
3D Printing Settings